[KEY] Camry (Vienta)SXV20/MCV20 Key programming

New transponder key
NOTE :

• This must be done when you have installed a new immobilizer ECU.

Procedure :

1. All doors closed, Key not in key cylinder,
2. Insert master key in the key cylinder,
3. Ignition switch LOCK to ON. 
4. Remove the master key.
• If you want to register the next master key, repeat step 2 within 10 sec.
5. Driver's door OPEN and CLOSE within 10 sec.
6. Insert the sub key in the key cylinder within 10 sec.
7. Ignition switch LOCK to ON within 10 sec.
8. Remove the sub key. 
• If you want to register the next sub key, repeat step 6 within 10 sec.

Registration of additional master keys

1. All doors closed and key not in key cylinder.
2. Insert already registered master key into the key cylinder.
3. Turn ignition switch LOCK to ON 5 time and leave the key position ON.
4. OPEN and CLOSE driver's door a further 6 times.
5. Remove the master key.
• NOTE : Step 2~5 must be operate within 20 sec.
6. Insert key to be registered into the key cylinder within 10 sec.
7. Turn ignition switch LOCK to ON within 10 sec.
8. Keep ignition switch at ON position for 60 sec or more.
9. Remove the key.
10. If you want to register another keys, repeat again step 7~11 within 10 sec.
11. OPEN and CLOSE driver's door once for complete.
• Allow an additional 50 sec for the extension timer to elapse prior to testing the system.

Registration of additional sub keys

1. All doors closed and key not in key cylinder.
2. Insert already registered master key into the key cylinder.
3. Turn ignition switch LOCK to ON 4 time and leave the key position ON.
4. OPEN and Close driver's door a further 5 times.
5. Remove the master key.
• NOTE : Step 2~5 must be operate within 20 sec.
6. Insert key to be registered into the key cylinder within 10 sec.
7. Turn ignition switch LOCK to ON within 10 sec.
8. Keep ignition switch at ON position for 60 sec or more.
9. Remove the key.
10. If you want to register another keys, repeat again step 7~11 within 10 sec.
11. OPEN and CLOSE driver's door once for complete.
• Allow an additional 50 sec for the extension timer to elapse prior to testing the system.

Erasure of transponder key code.

1. All doors closed and key not in key cylinder.
2. Insert already registered master key into the key cylinder.
3. Turn ignition switch LOCK to ON 6 time and leave the key position ON.
4. OPEN and Close driver's door a further 7 times within 15 sec.
5. Remove the master key.
• NOTE : Step 6~7 must be operate within 20 sec.
6. Complete.